Cold Water Inlet Pipe
The inlet pipe (usually copper) is connected to the main cold water
supply pipe and provides water to the tank. The
average temperature of the incoming cold water is 50° F.
Cold Water Control Valve
The cold water control valve allows the incoming cold water to be turned
on
and off. The valve may be turned off when the water heater is not in
use, in an emergency when the water heater leaks, or when the
water heater is being replaced or breaks down .
Cold Water Dip Tube
To prevent the incoming cold water from cooling the hot water leaving
the tank (at the top), the cold water is introduced at the bottom of
the tank (which is also closer to the heat source). When the cold water inlet
pipe is located at the top of the tank instead of at the bottom of the tank on the sidewall, a
dip tube is used to direct the cold water to the bottom of the tank.
Hot Water Outlet Pipe
The outlet pipe is a short pipe that extends into the top of the
tank. Since the water at the top of the tank is generally hotter than
the bottom (heat rises), the hot water is always taken from the top. The
average temperature of the hot water is 140° F,
however, for safety and energy conservation reasons, water heaters are often set to
120° F.
Anti-Corrosions or Sacrificial Anode
A rod placed in glass-lined metal water heater tanks to help
prevent the tank from rusting (oxidizing). The anode rod, usually made of
magnesium, attracts the corrosion-causing oxygen in the water. The rod
protects the tank from eroding, and eventually wears away. The rod must be
replaced to prevent the metal tank corrosion from accelerating.
Replace the anode every year or as necessary.
Drain Valve
The drain valve at the bottom of the water heater allows the tank to be
drained. Sludge or sediment from the water or the sacrificial anode will collect
at the bottom of the tank over time. Excessive sludge/sediment may
lower the water pressure or reduce the water heating efficiency. Recommended
maintenance includes draining the sludge once a year.
Temperature Pressure Relief Valve (TPRV)
The temperature pressure relief (TPR) valve is a safety device that is
designed to:
- prevent the water in the tank from exceeding 212° F, and
- prevent the water pressure in the tank from exceeding 150
pounds/square inch (psi).
TPRV Discharge Tube
A tube or pipe that is attached to the TPR valve to
direct the superheated water down to the floor and away from anyone
in the discharge area in order to prevent scalding or burning.
________________________________________________________________________
Water Heater Main Page
TPR Valve TPRV Discharge Tube
Water
Heater Safety & Efficiency
Gas Fired Water Heater Electric Water Heater
Oil
Fired Water Heater
Return
to the Top of the Page
